DVS Atomix HDMI Guide d'installation télécharger pdf (Page 35)

3-3

Installation

The computer system is now ready for the installation and you have to

proceed with the checking of the panels for their correct jumper set-

tings.

Jumper Settings of the Audio and RS-422 Panel

When installing the audio and RS-422 panel as the audio panel #1 (see

section “Note About the Audio Setup” on page 2-9), up to four stereo

channels of AES/EBU or three stereo channels of AES/EBU and one LTC

in- and output can be transmitted. This signal configuration has to be

configured via jumper settings on one of the printed circuit boards

mounted to the audio and RS-422 slot panel.

 Before installing the audio and RS-422 panel please check whether

the jumpers on the printed circuit boards are set to your desired

configuration and, if appropriate, adjust them:

Figure 3-1: Jumper settings for audio (audio panel #1)

After checking and, if appropriate, adjusting the jumpers you can con-

tinue the installation by checking the jumpers of the audio panels (if

available).

In a setup that contains this panel as well as one of the audio

panels (see section “Audio Panel” on page 2-12), it is recom-

mended to install it as audio panel #2 (see section “Note About

the Audio Setup” on page 2-9). Then the jumpers should be

set as the indicated in the left drawing (figure above, 4th audio

channel activated).

LTC activated

4th audio

channel activated

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 63 64

Pas de commentaire

DVS Atomix HDMI Guide d'installation Page 35