DVS Atomix HDMI Guide d'installation Page 45

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 64
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 44
3-13
Installation
3
2
1
I
4
A
3.4 Upgrading the Firmware
It is recommended to have the latest released firmware version installed
on the Atomix HDMI board. Depending on the currently installed firm-
ware it may require an upgrade. This can be done with a program
named ’atomixhdmiup’. This section explains how to determine wheth-
er you need and how to perform a firmware upgrade.
3.4.1 Determining the Firmware Version
Before upgrading the firmware you have to determine the firmware
version that is currently installed on your Atomix HDMI board and com-
pare it with the version suitable for your DVS SDK. For this perform the
following:
Open a command line (shell, or in case of Windows command
prompt (cmd)).
Enter at the command line svram version info and press
[Enter].
In the output look for the line that says Firmware Version:
7.4.0.11_7.0.10 or similar.
The numbers indicate the installed firmware version. In detail they
stand for two version numbers that are separated by an underscore, i.e.
with the pattern <v
1
>_<v
2
>.
Next check the readme.txt and changelog.txt of the DVS
SDK for information about the required firmware version. Notable
dependencies will be stated in these files.
An upgrade should be performed by qualified personnel only.
Before upgrading the firmware close all other applications.
Be aware of a power failure. If this happens, you have to use
the fallback firmware version of the Atomix HDMI board as
detailed in chapter “Maintenance” on page 4-1.
If the driver is not already loaded, load the driver. Further infor-
mation about this can be found in the separate SDK documen-
tation.
In case you have several Atomix HDMI boards installed, use
the environment variable SCSIVIDEO_CMD and set it to
PCI,card:<x> (with <x> as the number of the board, nor-
mally counting from zero (0)) to access a particular board.
Please refer to the SDK documentation for details about setting
the variable SCSIVIDEO_CMD.
Vue de la page 44
1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 63 64

Commentaires sur ces manuels

Pas de commentaire