DVS Atomix HDMI Guide d'installation télécharger pdf (Page 36)

3-4

Atomix HDMI Installation Guide

Jumper Settings of the Audio Panel(s)

On the audio panel that should be installed as the audio panel #1 (see

section “Note About the Audio Setup” on page 2-9) up to four stereo

channels of AES/EBU or three stereo channels of AES/EBU and one LTC

in- and output can be transmitted. This signal configuration has to be

configured via jumper settings on the printed circuit board mounted to

the audio slot panel.

 Before installing the audio panel #1 please check whether the jump-

ers on the printed circuit board are set to your desired configuration

and, if appropriate, adjust them:

Figure 3-2: Jumper settings for audio (audio panel #1)

 If available, check the jumper settings of the audio panel that

should be installed as the audio panel #2. They should be set as the

indicated in the left drawing (figure above, 4th audio channel acti-

vated).

After checking and, if appropriate, adjusting the jumpers of the audio

panels to their correct settings you can go on with the next step and

install the board into the computer system.

3.1.2 Installation of the Board

With the second step the Atomix HDMI board will be installed in the

prepared computer system. For this perform the following:

LTC activated

4th audio

channel activated

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 63 64

Pas de commentaire

DVS Atomix HDMI Guide d'installation Page 36