DVS Clipster Guide de l'utilisateur télécharger pdf (Page 158)

7-20

CLIPSTER I/O Tool User Guide

aspect ratio (16:9, 4:3, et al.). The SD outputs can be configured via the

Configuration Tool (see “CLIPSTER Configurations” user guide for

more information).

7.2.2 The Audio Format

Below the button to set the video format you can find the AUDIO FOR-

MAT… button. With it you can confirm prior to a record of audio in the

VTR task mode that your current setup is in accordance with the base

audio settings.

After pressing the AUDIO FORMAT… button the following window will

be displayed on the screen:

Figure 7-12: Audio input configuration

For informatory reasons this window shows you the audio configura-

tion of the base VTR timeline settings. Use the displayed settings to as-

certain prior to a record that the audio hardware setup matches the

configuration. The window can be closed with the OK as well as the

CANCEL button.

7.2.3 The Processing Type

With the processing type settings you have to determine the play-out

or record type, i.e. you have to select the type of material that you want

to record or play out. You can choose whether you want to process au-

dio and video separately, or both together.

Rasters for film not included in the SDI standard (i.e. 2K with

20 Hz or more) can be output via the analog and DVI outputs

only, while an input has to be performed via the DVI input.

These settings were determined during the creation of the VTR

timeline. Therefore, they are not available and cannot be

changed (see section “Creating a New VTR Timeline” on

page 7-3).

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 199 200

Pas de commentaire

DVS Clipster Guide de l'utilisateur Page 158